Home | Contact Us |Sitemap | Careers

Electrical, Instrumentation and Control Engineering Design

Our Design Office is fully equipped to produce documentation for the following:

  • Transformers and H.T. Switchgear.
  • L.T. Switchgear, power and lighting distribution boards.
  • Motor control centres.
  • Relay logic control
  • Programmable logic controls.
  • Power, control and signal cables.
  • Remote control centres push button stations.
  • Small power distribution.
  • Indoor and outdoor lighting.
  • Grounding, earthing and lightning protection.
  • Fire detection, alarm and other annunciation and protection systems.
  • Field mounted switches and sensors.
  • Back-up batteries, rectifiers and uninterrupted power supplies.
  • Generating sets and associated control equipment.
  • PLC, DCS and SCADA system.
  • Instrument panels, cabinets, console and relay racks.
  • Electronics and pneumatic instruments panel and field mounted items.
  • Tubing, air supplies system, impulse and signal systems.
  • Process analyzers, conductivity and pH meters.
  • Control valves, solenoid valves and pressure regulators.
  • Cathodic protection.

Preparation of following documents and drawings :

  • Equipment plot plans.
  • Indicative cable routing.
  • Cable and termination schedules.
  • Single line diagrams.
  • Control logic diagrams.
  • Instrument loop diagrams.
  • Schematic and inter-connection diagrams.
  • Lighting layouts.
  • Earthing and grounding system specifications and layout drawings.
  • Lightening protection systems specifications and drawings.
  • Specifications of switchgear, panel boards, motor control centres, distribution boards.
  • Specification and codes of practices for installation of electrical and control equipment.
  • Specifications for generator sets and motor drives.
  • Specifications & data sheets for PLC, DCS, SCADA, Control instruments, field instruments.
  • Installation details of field mounted items.
  • Preparation for inspection, testing, pre-commission and commissioning procedures.
  • Preparation of quality control procedures.
  • Material take-off, bills of quantities and bills of materials.
  • Cost estimates for procurement and installation of equipment and materials.

Nulla facilisi. Donec augue sem, interdume gestas cursus sit amet, cursus quis enim. Phasellus tortor nunc, sollicitudin sit amet scelerisque a, venenatis nec nulla.

Home  |  About  |  Services  |  Projects  |  Terms & Privacy
©2011 Flowtronix - All rights reserved.
Powered by   Technopsis.com.pk